Contact service if the fault remains.Ħ06 Communication error XA-PWM, K3. INFORMATION! Restart ECU 796īy switching the ignition on and off. For electric servo, check if the breaker switch for load handling is pressed down.Ħ05 Communication error XA-PWM, K2. INFORMATION! Turn off the hydraulicįunctions. STOP!Ħ04 Voltage feed error PWM outputs, ECU 796. Contact service if the faultĦ03 Reference voltage 10 V error, ECU 796. STOP! Restart ECU 796 by switching the ignition off and on, load the program. WARNING!Ħ02 Memory error, check sum ECU 796. WARNING!Ĥ06 Signal error from power cell stub axle or tilt cylinder Overload protection does not work. WARNING!Ĥ05 Defective position sensor for seat reversing. Turn the driver’s seat to position for forward operation. STOP!ģ90 Error on valve for variable pump for Optimum speed/Optimum rev, shortcircuit or open circuit at terminal. STOP!ģ84 Error, servo motor for injector pump engine. STOP!ģ83 Error, accelerator pedal RR (Right Rear). STOP!ģ82 Error, accelerator pedal LR (Left Rear). STOP!ģ81 Error, accelerator pedal (Right Front). Seeģ80 Error, accelerator pedal (Left Front). See separate manual for particleģ72 Particle filter engine. See separate manual for particleģ71 Particle filter engine. INFORMATION! Clean particle filter within 30 minutes. Check the accumulators’ sealing if the pressure does not build up and is not maintained, see chapter 6 Inspectionģ70 Particle filter engine.

That is, the brake pressure is too low and the service brake capacity is limited. INFORMATION!ģ57 Brake system, accumulator pressure low. Contactģ56 Sensor error, hydraulic oil temperature.

WARNING! Do not use hydraulic functions until the hydraulic oil temperature falls below 70☌. STOP! Fill with coolant.ģ55 Hydraulic oil temperature high. INFORMATION! Fill with fuel.ģ53 Sensor malfunction fuel level. STOP!ģ25 Short-circuit or open circuit, output signal PDC valve hydraulic motor. STOP!ģ24 Short-circuit or open circuit, output signal EDC valve pump (reverse). WARNING!ģ23 Short-circuit or open circuit, output signal EDC valve pump (forward). Engine rpm does not increase when using lift lever. STOP!ģ22 Malfunction of lift lever’s hydraulic pressure sensor. STOP!ģ21 Sensor malfunction hydrostatic operating pressure (reverse). STOP!ģ20 Sensor malfunction hydrostatic operating pressure (forward). STOP!ģ04 Sensor malfunction for electric scales. STOP: Check fuses according to the Operator’s manual, and the battery voltage and acidity.ģ03 Reference voltage error, 5V, ECU 790.

Error code po 306